This is a demonstration procedure authored in RapidAuthor using the
DITA 1.1 Specification.
Remove the Pump Valve Housing using number 15 wrench
Remove the Pump Valve Housing and inspect the rotors for cracks
and fouling. Replace as appropriate using Maintenance Procedure JC0346.
Prior to re-installation of the Pump Valve Housing, ensure the
gasket is resealed with the correct gasket sealant.
Reinstall the Pump Valve Housing.
Reinstall the Pump Valve. NOTE: Ensure that all bolts are
tightened to 25nm.
Loosen the pump adjuster by .5 turn.
Pump Procedure - DITA
Adjust Valve: Loosen the BLT005532